Editing ComputerSystemTask
From PCSAR
Warning: You are not logged in. Your IP address will be recorded in this page's edit history.
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
| Current revision | Your text | ||
| Line 2: | Line 2: | ||
SARCAR. | SARCAR. | ||
| - | ==Tasks== | + | ==Tasks:== |
* Determine requirements for SAR computer (done) | * Determine requirements for SAR computer (done) | ||
| - | * Important uses: photocopying, brifing sheet, maps | + | * Important uses: photocopying, brifing sheet, maps* What do we need when looking for computer sysem* Mass faxing* Topo map software that Bryan has* propose suitable components, get BoardCommittee approval (done)* buy system (mostly done) |
| - | * What do we need when looking for computer sysem | + | * buy 2-sided print option ([[PhotocopierTask]]): [[BrettWuth]]* install system |
| - | * Mass faxing | + | |
| - | * Topo map software that Bryan has | + | |
| - | * propose suitable components, get BoardCommittee approval (done) | + | |
| - | * buy system (mostly done) | + | |
| - | * buy 2-sided print option ([[PhotocopierTask]]): [[BrettWuth]] | + | |
| - | * install system | + | |
* physical housing: MikeStauffer, RussellBruder (done) | * physical housing: MikeStauffer, RussellBruder (done) | ||
| - | |||
requirements | requirements | ||
| - | * able to transport under high vibration (e.g. washboard) without damaging delicate scanning mechanism | + | * able to transport under high vibration (e.g. washboard) without |
| - | * enough space to be able to completely remove the lid (everything above the glass) in order to position large maps for scanning. Lid removes by lifting 2 tabs when lid is open. | + | damaging delicate scanning mechanism* enough space to be able to completely remove the lid |
| - | * enough space to open lid and to use sheet feeder | + | (everything above the glass) in order to position large maps for |
| - | * enough space to print legal size (14 inch) paper without crowding into corridor | + | scanning. Lid removes by lifting 2 tabs when lid is open.* enough space to open lid and to use sheet feeder* enough space to print legal size (14 inch) paper without |
| - | * enough space to open printer to replace ink cartridges. Printer hinges open in the middle by pulling forward where paper comes out. | + | crowding into corridor* enough space to open printer to replace ink cartridges. Printer |
| - | * glass level with counter top to allow large maps to slide on and off printer | + | hinges open in the middle by pulling forward where paper comes |
| - | * as much space as possible between the printer and the two walls of the corner so as to allow maps to hang over all four edges when scanning large maps. | + | out.* glass level with counter top to allow large maps to slide on |
| - | * easy to reach access to front panel buttons | + | and off printer* as much space as possible between the printer and the two walls |
| - | * the printer will become 2 inches wider (front to back) at the bottom back when the 2-sided print option is purchased. Because the top back currently overhangs the bottom back, this won't make the printer significantly wider (front to back). | + | of the corner so as to allow maps to hang over all four edges when |
| - | * the power inverter needs to attach somewhere to the wall (as a heat sink) and to 12 V. It will power both the printer and the laptop, which will set on the counter. | + | scanning large maps.* easy to reach access to front panel buttons* the printer will become 2 inches wider (front to back) at the |
| - | * a cord will run between the laptop and the printer. | + | bottom back when the 2-sided print option is purchased. Because the |
| - | * install power inverter | + | top back currently overhangs the bottom back, this won't make the |
| - | * cache printer paper at firehall and in SARCAR | + | printer significantly wider (front to back).* the power inverter needs to attach somewhere to the wall (as a |
| - | * build pictoral of how to pack, carry, transport, unpack | + | heat sink) and to 12 V. It will power both the printer and the |
| - | * label | + | laptop, which will set on the counter.* a cord will run between the laptop and the printer.* install power inverter* cache printer paper at firehall and in SARCAR* build pictoral of how to pack, carry, transport, unpack* label weigth of case and printer* software selection and configuration: [[BrettWuth]]* Mapping Software |
| - | * software selection and configuration: [[BrettWuth]] | + | * consider MemoryMap (demoed by RoyDavidson) [http://www.memory-map.com/] Will it |
| - | * Mapping Software | + | run under Linux?* convert to journaling file system (ext3) |
| - | * consider MemoryMap (demoed by RoyDavidson) http://www.memory-map.com/ Will it run under Linux? | + | [http://www.troubleshooters.com/linux/ext2toext3.htm] |
| - | * convert to journaling file system (ext3) http://www.troubleshooters.com/linux/ext2toext3.htm | + | |
| - | + | ||
| - | + | ||
| - | + | ||
| - | + | ||
| + | * train people to useBrett Wuth, 2005/02/21 23:28 MST (via web): | ||
Used to be assigned to [[BrettWuth]], but removed due to higher | Used to be assigned to [[BrettWuth]], but removed due to higher | ||
priorities | priorities | ||
