Rope Rescue/Equipment/Need/I-beam rigging clamps
From PCSAR
(Difference between revisions)
| Line 24: | Line 24: | ||
** http://www.ahsrescue.com/p-1223-pmi-tractel-beam-clamp.aspx | ** http://www.ahsrescue.com/p-1223-pmi-tractel-beam-clamp.aspx | ||
** http://shop.pmirope.com/technical-hardware/index.aspx?pageID=43&productID=333&productMasterID=333 | ** http://shop.pmirope.com/technical-hardware/index.aspx?pageID=43&productID=333&productMasterID=333 | ||
| + | |||
| + | |||
| + | * RELIANCE LockJaw Remote Beam Grip Clamp | ||
| + | ** min width 5 inch | ||
| + | ** http://www.gravitec.com/equipment/anchors/reliance-lockjaw-remote-beam-grip-clamp/anc-re-3040-1/ | ||
| + | |||
* possible sources: | * possible sources: | ||
** possibly live load rated: | ** possibly live load rated: | ||
| - | |||
*** http://www.westernsafety.com/falltech/falltech08pg3.html | *** http://www.westernsafety.com/falltech/falltech08pg3.html | ||
** rating not obvious: | ** rating not obvious: | ||
Revision as of 12:33, 19 March 2011
I-beam rigging clamps
- for training at Fire Hall
- slanted I-beams 4 inches wide
- horizontal I-beams approx 7-8 inches wide
- requirements yet to be defined
possible products:
- Universal SUPERCLAMP
- Can be Loaded at Any Angle
- Approved for Personnel Anchoring (tie-off)
- http://www.lamcoinc.com/beamclamp.html
- Beam Clamp
- 3 - 9" flange widths
- WLL, Personal 2,000 lbf.
- http://www.rescuetech1.com/beamclamp.aspx
- PMI Tractel Beam Clamp
- This anchorage is designed to fit I-beams from 3 to 8.25 inches. Simple installation, removable. Meets ANSI, CSA, and OSHA 5400lbs (24kN) anchorage requirements.
- one person rated.
- 24kN should be sufficient for 2 person load at rescue SSSF because not weakened by knot.
- http://www.ahsrescue.com/p-1223-pmi-tractel-beam-clamp.aspx
- http://shop.pmirope.com/technical-hardware/index.aspx?pageID=43&productID=333&productMasterID=333
- RELIANCE LockJaw Remote Beam Grip Clamp
- possible sources:
- possibly live load rated:
- rating not obvious:
